![]() 09/23/2017 at 22:26 • Filed to: None | ![]() | ![]() |
I’m rebuilding a yamaha xt225, working on the carb now. The float bowl was full of powder from sitting for several years. I am replacing some parts (basically if I think I need to), the floats look pretty beat to shit. Looked up online - $60+ for a little piece of plastic and some metal
Found some aftermarket ones for $35 but still, shit. I thought it would be like $10-20...
![]() 09/23/2017 at 22:33 |
|
Dennis Kirk has them for under $30.
That’s still a lot for floats. But..
![]() 09/23/2017 at 22:48 |
|
Are there holes in them? I wouldn’t think plastic floats would be prone to failure. The old school metal ones crack as they’re usually two pieces welded together. Throw them in a glass of water and check for bubbles. That’s a lot for floats.
![]() 09/23/2017 at 23:10 |
|
Any chance a 3D printed part would work?
![]() 09/24/2017 at 02:30 |
|
Ethanolated fuels don’t play nice with fuel systems on older stuff not meant to work with E10.
![]() 09/24/2017 at 02:36 |
|
I own a ‘73 CL450 and a ‘66 GMC. The XT225 is a much newer bike than some of the stuff I’m used to. I don’t think ethanol is going to affect plastis anymore than regular gasoline would. I owned a 2002 Ford Ranger which was designed to partially run on E85.
![]() 09/24/2017 at 09:13 |
|
I ordered already but good idea. They were white originally, they’re now a dark brown in most spots, and the plastic is pretty soft in spots (like a ziploc bag almost)
![]() 09/24/2017 at 16:49 |
|
Im my experience printed parts are always slightly porous and could work temporarily, but I think would fail.